Toys & Games
|Home » |
|Average Customer Rating:
|| based on 257 reviews|
Average Customer Review:
( 257 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
192 of 207 found the following review helpful:
Extra fun with a few minutes of workNov 16, 2010
This toy was very educational- it got me thinking, and inspired creativity.
This button is AMAZING! My boss has an easy button, so of course I had to get one too... because I'm just that kind of employee...lol... riiiiight. I wondered if I could swap the guts of an easy button with a BS button... so I ordered both on Amazon, and had some fun doing a little creative soldering, trimming of internal plastic (under "easy"), and use of a rubber band to hold the pressure button from the easy button in place on the BS button after soldering the wires (see below for walk-through).
A switcheroo when he was out of his office, and presto: an innocuous looking button that lets out a random phrase letting you know what it REALLY was (hint: not easy)! That was easy.
DISCLAIMER: I work in an agency with a "high ops-tempo" and difficult cases where "everything is a crisis," and most importantly, a boss who gets my sense of humor. Try this at your own risk.
Remove feet from easy button, set aside (don't lose), sticky side up.
Separate halves of buttons, and carefully remove wires from easy button board (leaving them on the battery pack and speaker for ease), and BS button board.
I recommend soldering to the back of the BS board (just find the appropriate spot and solder- it beats trying to jam wires into the board- good luck with that)
Your red wires become speaker wires, so solder those to their proper spot on the BS button.
Blk stays blk, so just solder that wire to the GND spot.
The white wire goes to where the red used to go, so solder that to the VCC spot.
You left the yellow and blue wires dangling from the LED on the BS button shell, so don't worry about those. They don't get used.
Loosely screw your Frankenstein's Monster's Trojan Button's guts down in one spot using an existing screw hole- button side down. Leave room to slide the metal plate back in place (it's makes a pop/click noise when you press the button, and is necessary for a convincing transformation).
Now would be a good time to affix the pressure switch (the rubber button from the top of the easy button). It will work on the BS button board to complete the circuit. I used a rubber band to hold the pressure switch in place (loop it around the middle of the board from one side of the switch, and back over the switch to hold it down).
On the back of the easy button's red shell there are four posts. You'll have to clip them almost all the way down. If you've tried to screw it down before now (impatient, aren't we), you'll have noticed that it doesn't fit. Keep clipping until it fits snugly over the top and you can slide the metal plate back under the guts so when it's all assembled the pressure pushes the guts down onto the pressure switch and clicks the plate at the same time). Screw it back together, and replace the feet.
Let the fun begin!
23 of 25 found the following review helpful:
If you want a kinda funny redneck then get this.Jan 25, 2013
I don't know what I expected but it definitely wasn't some redneck making kinda funny BS jokes. It's not that it's bad. It's just not what i would of ordered if I'd known.
These are the things he says:
If BS were money you'd be a billionaire.
Step right up and get you're BS here.
Now that was Grade A BS
If it gets any deeper in here, I'll need a ladder to climb out.
BS Alert BSss Alert
Everybody put on your helmets BS is being flung.I repeat BS is being flung. *my favorite.
What a croc of BS
40 of 48 found the following review helpful:
Fun toy for adults- tell management and coworkers how you feelJul 19, 2007
By W. Wylie
I keep my BS button by my desk. Whenever someone comes to me with a ridiculous question, an absurd assignment, or opinion that they should have left at THEIR desk, I push my BS button. Nothing clarifies communications, shortens discussions, or moves managers along faster than a healthy does of "That Was BS!"
42 of 54 found the following review helpful:
great for home useApr 26, 2010
By A. Rosenberg
I bought one of these about three months ago for use with the missus. I got tired of hearing all of her complaints, such as I haven't increased her household allowance since 1978 and I keep coming home smelling of cheap perfume. This button has really kept her shut up!
This morning, I was served with divorce papers. You know what I think about that? BULLSH....
24 of 30 found the following review helpful:
BS button tells it like it is!Jun 07, 2007
By C. Brown
I love it! The first time that I saw the BS button was when a co-worker brought one in that he bought locally. Another co-worker of mine found the BS button on Amazon; I immediately ordered two. The one that I intended to keep for myself is now a fixture in one of my hangouts and gets heavy use and my significant other has the other one, which has also seen heavy use. I heartily recommend the BS button as a fun thing & recommend DollTV as the place to buy one.
See all 257 customer reviews on Amazon.com